INSTRUCTIONS
1) Connect the supplied cable from the HDTV HDMI sources into the 1x4 HDMI Splitter input. HDMI
to HDMI cable for HDMI source or HDMI to DVI cable for DVI source.
2) Connect the cables from your displays (monitor or projector) into the HDMI outs of the 1x4 HDMI
Splitter.
3) Plug the 5VDC power supply into the 1x4 HDMI Splitter.
DIP SWITCH GUIDELINES
Inside the HDMI1X4 is a bank of Dip Switches. Below is a table describing their functions. By default,
all switches are set to the Off position.
Dip Switch #
Name
Description
1
2
3
4
5
6
7
8
Switching Delay
On Board EDID
Adds a 3 second delay to switching
Feeds a generic HDMI EDID (720p/1080i) to all inputs
IR Code Dip Switch Corresponds to Dip Switch 1 on RMT16-IR
IR Code Dip Switch Corresponds to Dip Switch 2 on RMT16-IR
Unused
Unused
Unused
-
-
-
Edge Select
+ Edge Pixels
How to open the 1x4 HDMI Splitter:
To access the dip switches, just remove the four screws on the bottom. Slide the top portion off of the
bottom and you should see the dip switches on the board.
- 3 -
SPECIFICATIONS
1.65 Gbps
Video Amplifier Bandwidth
Input Video Signal
Input DDC Signal
Single Link Range
Input Connector Type
Output Connector Type
Power Consumption
Power Supply
1.2 volts p-p
5 volts p-p (TTL)
1080p / 1920 x 1200
HDMI Type A 19 pin female
HDMI Type A 19 pin female
10 Watts (max.)
5V DC
Dimensions
Shipping Weight
12”W x 1.25”H x 4.125”D
5 lbs.
Technical Support
Mailing Address
Hours:
Phone:
7AM-5PM Pacific
800.843.5465
press 2 for Tech Support
800.492.6832
Xantech Corporation
13100 Telfair Avenue, 2/F
Sylmar, CA 91342
Fax:
email:
HDMI1X4 User Manual © 2007 Xantech Corporation
This document is copyright protected. No part of this manual may be copied or reproduced in any
form without prior written consent from Xantech Corporation.
Document Number 08905131A
- 4 -
|